Using a caliper gauge, measure the bush bore diameter of the cylinder head.
Select a new guide bush (STD or O/S 0.05):
Bush Size
Bush Bore Diameter
Use STD
13.004 to 13.025 mm (0.5120 to 0.5128 in.)
Use O/S 0.05
13.054 to 13.075 mm (0.5139 to 0.5148 in.)
If the bush bore diameter of the cylinder head is greater than 13.025 mm (0.5128 in.), machine the bush bore to dimension of 13.054 to 13.075 mm (0.5139 to 0.5148 in.). If the bush bore diameter of the cylinder head is greater than 13.075 mm (0.5148 in.), replace the cylinder head.
Gradually heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
Using SST and a hammer, tap in a new guide bush to the specified protrusion height.
Using a sharp 8.0 mm reamer, ream the guide bush to obtain the standard specified clearance between the guide bush and valve stem.
5.
INSTALL EXHAUST VALVE GUIDE BUSH
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
Select a new guide bush (STD or O/S 0.05):
Bush Size
Bush Bore Diameter
Use STD
13.004 to 13.025 mm (0.5120 to 0.5128 in.)
Use O/S 0.05
13.054 to 13.075 mm (0.5139 to 0.5148 in.)
If the bush bore diameter of the cylinder head is greater than 13.025 mm (0.5128 in.), machine the bush bore to dimension of 13.054 to 13.075 mm (0.5139 to 0.5148 in.). If the bush bore diameter of the cylinder head is greater than 13.075 mm (0.5148 in.), replace the cylinder head.
Gradually heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
Using SST and a hammer, tap in a new guide bush to the specified protrusion height.