2014 Hilux · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. REMOVE GENERATOR PULLEY CAP
  1. Using a screwdriver, remove the generator pulley cap from the generator pulley with clutch.


2. LOOSEN GENERATOR PULLEY WITH CLUTCH
  1. Mount the generator assembly in a vise between aluminum plates.

    NOTICE:
    Do not damage the generator.

  1. A200681E01
    Set SST and an 8 mm bi-hexagon wrench to the pulley as shown in the illustration.
    SST
    09820-30010  

  1. A200682E01
    Hold SST in place, rotate the 8 mm bi-hexagon wrench clockwise, and loosen the generator pulley with clutch.


3. REMOVE GENERATOR REAR END COVER

  1. A117269
    Remove the 2 terminal covers by turning them counterclockwise.

  1. A117270
    Using a 15 mm socket wrench, remove the 2 nuts from the end cover.

  1. Remove the screw and end cover.


4. REMOVE GENERATOR REGULATOR ASSEMBLY
  1. Remove the protective tower.

  1. A117271
    Remove the 3 screws and regulator assembly.


5. REMOVE GENERATOR STATOR SUB-ASSEMBLY WITH RECTIFIER

  1. A117272
    Remove the 4 screws.

  1. A117273
    Using a screwdriver, pry off the stator.


6. REMOVE FITTING RING

A117274

7. REMOVE GENERATOR ROTOR ASSEMBLY

NOTICE:
Do not drop the generator rotor assembly.

  1. Remove the generator pulley with clutch.

  1. A117276
    Using a press, press out the generator rotor assembly and remove the spacer ring.

← REMOVAL (from Aug 2013)INSPECTION (from Jun 2011) →