DISASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1. REMOVE GENERATOR PULLEY CAP |
Using a screwdriver, remove the generator pulley cap from the generator pulley with clutch.
| 2. LOOSEN GENERATOR PULLEY WITH CLUTCH |
Mount the generator assembly in a vise between aluminum plates.
- NOTICE:
- Do not damage the generator.
Set SST and an 8 mm bi-hexagon wrench to the pulley as shown in the illustration.

- SST
- 09820-30010
Hold SST in place, rotate the 8 mm bi-hexagon wrench clockwise, and loosen the generator pulley with clutch.

| 3. REMOVE GENERATOR REAR END COVER |
Remove the 2 terminal covers by turning them counterclockwise.

Using a 15 mm socket wrench, remove the 2 nuts from the end cover.

Remove the screw and end cover.
| 4. REMOVE GENERATOR REGULATOR ASSEMBLY |
Remove the protective tower.
Remove the 3 screws and regulator assembly.

| 5. REMOVE GENERATOR STATOR SUB-ASSEMBLY WITH RECTIFIER |
Remove the 4 screws.

Using a screwdriver, pry off the stator.

| 6. REMOVE FITTING RING |
![]() ![]() |
| 7. REMOVE GENERATOR ROTOR ASSEMBLY |
- NOTICE:
- Do not drop the generator rotor assembly.
Remove the generator pulley with clutch.
Using a press, press out the generator rotor assembly and remove the spacer ring.


