REASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1. INSTALL GENERATOR ROTOR ASSEMBLY |
- NOTICE:
- Do not drop the generator rotor assembly.
Set the spacer ring, drive end frame, generator rotor assembly and SST1 to SST2 as shown in the illustration.

- SST
- 09285-76010
09630-00014 (09631-00061)
Using SST1, SST2 and a press, slowly press the generator rotor into the drive end frame and spacer ring.
Temporarily install the generator pulley with clutch to the rotor shaft by hand.
| 2. INSTALL FITTING RING |
Align the 3 protrustions of the fitting ring with the 3 cutouts of the generator stator with rectifier and install the fitting ring.

| 3. INSTALL GENERATOR STATOR SUB-ASSEMBLY WITH RECTIFIER |
Align the key of the drive end frame with the keyway of the generator stator.
Install the stator with the 4 bolts.

- Torque:
- 4.3 N*m{ 44 kgf*cm , 38 in.*lbf }
| 4. INSTALL GENERATOR REGULATOR ASSEMBLY |
Push in the regulator by hand as shown in the illustration.

Install the regulator with the 3 screws.


- Torque:
- 2.5 N*m{ 25 kgf*cm , 22 in.*lbf } for screw A
- 1.2 N*m{ 12 kgf*cm , 11 in.*lbf } for screw B
- HINT:
- Install screw B to the position shown in the illustration.
Install the protective tower.
| 5. INSTALL GENERATOR REAR END COVER |
Install the rear end cover with the 2 nuts and screw.

- Torque:
- 19 N*m{ 194 kgf*cm , 14 ft.*lbf } for nut A
- 12 N*m{ 122 kgf*cm , 9 ft.*lbf } for nut B
- 2.8 N*m{ 29 kgf*cm , 25 in.*lbf } for screw
- NOTICE:
- The protective tower must be attached to the end cover.
Install the 2 terminal covers by turning them clockwise.

| 6. TIGHTEN GENERATOR PULLEY WITH CLUTCH |
Mount the generator assembly in a vise between aluminum plates.
Set SST and an 8 mm bi-hexagon wrench to the pulley as shown in the illustration.

- SST
- 09820-30010
Hold SST in place, rotate the 8 mm bi-hexagon wrench counterclockwise, and tighten the generator pulley with clutch.

- Torque:
- 80 N*m{ 816 kgf*cm , 59 ft.*lbf }
| 7. INSTALL GENERATOR PULLEY CAP |
Install a new generator pulley cap.

- NOTICE:
- Align the cap guide of the generator pulley cap with the hole of the generator pulley and push it in by hand.
- Do not push in the generator pulley cap at an angle.
- Align the cap guide of the generator pulley cap with the hole of the generator pulley and push it in by hand.
