2014 Hilux · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. A/C switch is ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Using SST, Recover the refrigerant from the A/C system using a refrigerant recovery unit.

    SST
    09985-20010   (09985-02130, 09985-02150, 09985-02090, 09985-02110, 09985-02010, 09985-02050, 09985-02060, 09985-02070)


2. REMOVE AIR CLEANER ASSEMBLY
  1. Disconnect the IAT sensor connector.

  1. Loosen the air cleaner hose clamp.

  1. Remove the 3 bolts and air cleaner.


3. REMOVE DRIVE BELT
(Click here)

4. DISCONNECT SUCTION HOSE SUB-ASSEMBLY

  1. E232509
    Remove the bolt and disconnect the suction hose sub-assembly from the compressor.

  1. Remove the O-ring from the suction hose sub-assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


5. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

  1. E232510
    Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor.

  1. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


6. REMOVE COOLER COMPRESSOR ASSEMBLY

  1. E232511
    Disconnect the connector.

  1. E232512
    Remove the 4 bolts and cooler compressor assembly.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →