U0101 Lost Communication with TCM
Diagnostic trouble codes · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The ECM (engine control unit) intercommunicates with the TCM (transmission control ECU) through the Controller Area Network (CAN).If there is a problem in this intercommunication, the ECM sets a DTC.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| U0101 |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
| 1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC U0101) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the tester ON.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs.
- Result:
Display (DTC output)
Proceed to
U0101
A
U0101 and other DTCs
B
- HINT:
- If any DTCs other than U0101 are output, troubleshoot those DTCs first.
|
|
||||
| A | |
| 2. INSPECT TCM |
Disconnect the T38 TCM connector.

Turn the ignition switch ON.
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Specified Condition
BATT (T38-5) - Body ground
11 to 14 V
Disconnect the T19 TCM connector.

Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
E1 (T19-1) - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (ECM - TCM) |
Disconnect the E6 ECM connector.

Disconnect the T38 TCM connector.
Measure the resistance of the wire harness side connector.
- Standard resistance (Check for open):
Tester Connection
Specified Condition
CAN+ (E6-22) - CAN+ (T38-21)
Below 1 Ω
CAN- (E6-21) - CAN- (T38-20)
Below 1 Ω
- Standard resistance (Check for short):
Tester Connection
Specified Condition
CAN+ (E6-22) or CAN+ (T38-21) - Body ground
10 kΩ or higher
CAN- (E6-21) or CAN- (T38-20) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 4. REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 5. CHECK WHETHER DTC OUTPUT RECURS (DTC U0101) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs.
- Result:
Display (DTC output)
Proceed to
No output
A
U0101
B
|
|
||||
| A | ||
| ||
