2014 Hilux · Service Manual DRIVE LINE

INSPECTION

Inspection · Vehicles built from Aug 2014

Versions by build date: Jun 2011 – Jul 2014 from Aug 2014


CHECK TRANSFER OIL
  1. Remove the case plug (for filler) and gasket.

  1. C083746E01
    Check that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (for filler) hole.
    If the result is not as specified, add transfer oil.

    Transfer Oil:
    Transfer Oil Type
    Oil grade
    Viscosity
    Gear Oil
    GL-4 or GL-5
    SAE 75W-90
    Toyota Genuine Transfer Gear Oil LF or Equivalent
    -
    SAE 75W

    NOTICE:
    1. After changing the oil, drive the vehicle and check the oil level again.
    2. Too much or too little oil will lead to transfer problems.

    HINT:
    Since both types of transfer oil are interchangeable, either type may be added to the transfer assembly.

  1. When the oil level is too low, check for oil leakage.

  1. Install a new gasket into the case plug (for filler) and then tighten the plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


ADD TRANSFER OIL
  1. Remove the case plug (for filler) and gasket.

  1. Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the case plug (for filler) hole.

    NOTICE:
    1. When adding oil, pour it slowly.
    2. Add oil a little at a time, waiting several minutes between each addition of oil.

  1. Wait approximately 5 minutes and check that the oil level has not changed.

  1. Install a new gasket and the case plug (for filler).

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

← INSPECTION (Jun 2011 – Jul 2014)COMPONENTS (Jun 2011 – Jul 2013) →