SERVICE DATA
Specifications · Vehicles built from Jun 2011
- Venturi (Throttle control motor):
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
18 to 22 Ω
2 - 3
20°C (68°F)
18 to 22 Ω
4 - 5
20°C (68°F)
18 to 22 Ω
5 - 6
20°C (68°F)
18 to 22 Ω
- Venturi (Throttle open switch):
Tester Connection
Condition
Specified Condition
1 - 2
Fully open
Below 1 Ω
1 - 2
Fully close
10 kΩ or higher
- Crankshaft position sensor:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
22 to 28 Ω
- Engine coolant temperature sensor:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
2.32 to 2.59 Ω
1 - 2
80°C (176°F)
0.310 to 0.326 Ω
- Intake air temperature sensor:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
2.09 to 2.81 Ω
- Integration relay:
Tester Connection
Condition
Specified Condition
1J-4 - Body ground
Ignition switch ON
10 to 14 V
- Manifold absolute pressure sensor (Harness side):
Tester Connection
Condition
Specified Condition
M3-3 (VC (+)) - M3-1 (E2 (-))
Ignition switch ON
4.75 to 5.25 V
- Manifold absolute pressure sensor (Apply vacuum and pressure):
Applied Vacuum
Condition
Specified Condition
13.3 kPa (100 mmHg, 3.94 in. Hg)
Decrease
0.3 to 0.5 V
26.7 kPa (200 mmHg, 7.84 in. Hg)
Decrease
0.6 to 0.8 V
40.0 kPa (300 mmHg, 11.81 in. Hg)
Decrease
0.95 to 1.15 V
19.6 kPa (0.20 kgf/cm2, 2.84 psi)
Increase
0.4 to 0.7 V
39.2 kPa (0.40 kgf/cm2, 5.69 psi)
Increase
0.9 to 1.2 V
58.8 kPa (0.60 kgf/cm2, 8.53 psi)
Increase
1.5 to 1.8 V
78.5 kPa (0.80 kgf/cm2, 11.4 psi)
Increase
2.0 to 2.3 V
98.0 kPa (1.00 kgf/cm2, 14.2 psi)
Increase
2.5 to 2.8 V
- Accelerator pedal rod:
Tester Connection
Condition
Specified Condition
Intelligent tester to the DLC3
Ignition switch ON
0.6 to 1.0 V