Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
Circuit diagnosis · Vehicles built Nov 2011 – Jul 2012
Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Jul 2012 Aug 2012 – Jul 2013
DESCRIPTION
The No. 1 stereo jack adapter assembly sends an external device sound signal to the radio receiver assembly through this circuit.The sound signal that has been sent is amplified by the radio receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio receiver assembly or speakers.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO JACK ADAPTER) |
Disconnect the R17 and R20 radio receiver assembly connectors.
Disconnect the N4 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R17-28 (VAL+) - N4-6 (ALO)
Always
Below 1 Ω
R17-26 (VAR+) - N4-5 (ARO)
R17-27 (VA-) - N4-7 (ASGN)
R17-11 (AGND) - N4-9 (AGND)
R17-25 (ADPG) - N4-8 (AUXO)
R20-2 (US1-) - N4-2 (UDO-)
R20-3 (US1+) - N4-3 (UDO+)
R17-28 (VAL+) - Body ground
Always
10 kΩ or higher
R17-26 (VAR+) - Body ground
R17-27 (VA-) - Body ground
R17-11 (AGND) - Body ground
R17-25 (ADPG) - Body ground
R20-2 (US1-) - Body ground
R20-3 (US1+) - Body ground
|
|
||||
| OK | ||
| ||
