2014 Hilux · Service Manual HEATER & AIR CONDITIONING SYSTEM

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Jun 2011


CHECK INDICATOR

  1. E231078
    Turn the ignition switch to ON while pressing the air conditioning control AUTO and recirculation switches simultaneously.

  2. E231079E01
    Check that the indicators turn on and off 4 times at 1 second intervals.

    HINT:
    After the indicator check is completed, the system enters the DTC check mode automatically.

    Text in Illustration 
    *a
    Blinking Pattern
    *b
    On
    *c
    Off
    *d
    1 sec.
    *e
    4 times


CHECK DTC (SENSOR CHECK)

  1. E231080E01
    After the indicator check is completed, check that the system enters the DTC check mode automatically.

    HINT:
    1. Press the OFF switch to cancel the check mode.
    2. In the sensor check mode, troubleshooting may be only partially completed. Be sure to perform the actuator check, and then perform the sensor check again.

    Text in Illustration 
    *a
    Diagnostic Trouble Code (DTC)

  2. Read the DTCs displayed on the panel (temperature display). Refer to the list of DTCs (Click here) when reading the codes.

  3. If manual switching of the DTC display is desired, press the front DEF switch. This will stop the automatic progression of the DTC display. The DTC display can then be advanced manually by pressing the front DEF switch.


CLEAR DTC

  1. There are 2 methods for clearing the DTC memory.

    1. E231081
      During sensor check, press the front DEF switch and rear DEF switch at the same time.

    2. E225626E01
      Remove the ECU-B NO.2 fuse from the engine room relay block and junction block assembly for 20 seconds or more.
      Text in Illustration 
      *1
      Engine Room Relay Block and Junction Block Assembly
      *2
      ECU-B NO.2 Fuse

← DIAGNOSIS SYSTEM (from Jun 2011)DATA LIST / ACTIVE TEST (from Jun 2011) →