2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011

NOTICE:
  1. When replacing the fuel supply pump, also replace the injection pipe.
  2. After removing the injection pipes and fuel inlet pipe, clean them with a brush and compressed air.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE UNDER COVER (for 4WD)
  1. Remove the 4 bolts and under cover.


3. REMOVE NO. 2 ENGINE UNDER COVER (for 4WD)
  1. Remove the 4 bolts and under cover.


4. LOOSEN FUEL TANK CAP ASSEMBLY

5. DRAIN FUEL

6. DRAIN AUTOMATIC TRANSMISSION FLUID

7. REMOVE RADIATOR ASSEMBLY
  1. Remove the radiator assembly (Click here).


8. REMOVE TIMING BELT
  1. Remove the timing belt (Click here).


9. REMOVE FUEL INLET PIPE SUB-ASSEMBLY

  1. A152281
    Remove the bolt and clamp.

  1. A153562
    Remove the bolt and oil level gauge guide.

  1. A152282E02
    Using a 17 mm union nut wrench, loosen the union nuts and remove the fuel inlet pipe.


10. REMOVE SUPPLY PUMP ASSEMBLY

  1. A153558
    Disconnect the 2 fuel hoses.

  1. A153559
    Disconnect the 2 connectors.

  1. A070710E01
    Remove the 4 bolts indicated by the arrows in the illustration.

  1. Remove the No. 2 camshaft timing pulley flange and pump drive shaft pulley.

  1. A070711E02
    Remove the set nut and O-ring while holding the crankshaft pulley by using SST.
    SST
    09213-58013  
    09330-00021  

  1. A153560
    Loosen the 2 nuts.

  1. A070714E01
    Using SST, disconnect the pump from the injection gear.
    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply lubricant to the threads and tip of SST (center bolt) before using it.

  1. Remove the 2 nuts and pump.

    NOTICE:
    1. Do not hold the pump or carry it holding the pipe.
    2. The pump must be kept horizontal.

  1. Remove the O-ring.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →