C1420 Acceleration Sensor Malfunction
Diagnostic trouble codes · Vehicles built Jun 2011 – Oct 2011
Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Mar 2012 Apr 2012 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The skid control ECU (brake actuator assembly) receives signals from the yaw rate sensor assembly via the CAN communication system.The yaw rate sensor assembly has a built-in acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate sensor assembly and the CAN communication system, DTCs U0123 (Lost Communication with Yaw Rate Sensor Module) and U0124 (Lost Communication with Lateral Acceleration Sensor Module) are stored.
DTC C1420 is also stored when calibration is not completed.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1420 |
After the difference between GL1 and GL2 becomes 0.6 G or more with the vehicle stationary, the difference remains 0.4 G or more for 60 seconds or more. |
|
INSPECTION PROCEDURE
- NOTICE:
- After replacing the yaw rate sensor assembly, perform calibration (Click here).
- HINT:
- When DTC U0123 and/or U0124 is output together with DTC C1420, inspect and repair the trouble areas indicated by DTC U0123 and/or U0124 first (Click here).
| 1. CHECK YAW RATE SENSOR ASSEMBLY INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate sensor assembly is installed properly (Click here).
- OK:
- The sensor is tightened to the specified torque.
- The sensor is not installed at an angle.
|
|
||||
| OK | ||
| ||
