C1428 Motor Circuit Malfunction
Diagnostic trouble codes · Vehicles built Nov 2011 – Mar 2012
Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Mar 2012 Apr 2012 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1428 |
With the motor relay off and the motor fail-safe relay on, an open in the motor circuit continues for 2 seconds or more. |
Brake actuator assembly (Motor circuit) |
WIRING DIAGRAM
Refer to DTCs C0273, C0274 and C1361 (Click here).INSPECTION PROCEDURE
- NOTICE:
- After replacing the brake actuator assembly, perform calibration (Click here).
- Before disconnecting the connector, make sure that there are no problems with the connection.
- After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.
- After replacing the brake actuator assembly, perform calibration (Click here).
| 1. CHECK HARNESS AND CONNECTOR (GND2 TERMINAL) |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
S35-13 (GND2) - Body ground
Always
Below 1 Ω
Result Result
Proceed to
NG
A
OK
for LHD
B
for RHD
C
|
|
||||
|
|
||||
| A | ||
| ||
