INSTALLATION
Removal / installation · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Use the same procedure for the RH and LH sides.
| 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH (for Single Cab) |
Attach the 2 claws and temporarily install the 2 bolts in the order shown in the illustration (arrows 1 through 4).


Attach the 2 claws in the order shown in the illustration (arrows 5 and 6).
Tighten the 3 bolts in the order shown in the illustration (arrows 1 through 3).


- Torque:
- 11 N*m{ 112 kgf*cm , 8 ft.*lbf }
- NOTICE:
- Do not twist the curtain shield airbag assembly LH when installing it.
Attach the 4 claws and install the 4 bolts in the order shown in the illustration to install the curtain shield airbag assembly LH (arrows 4 through 11).
- Torque:
- 11 N*m{ 112 kgf*cm , 8 ft.*lbf }
- NOTICE:
- Do not twist the curtain shield airbag assembly LH when installing it.
Connect the connector.

- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
| 2. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH (for Extra Cab) |
Attach the 6 claws in the order shown in the illustration (arrows 1 through 6).


Install the 4 bolts in the order shown in the illustration (arrows 7 through 10).
- Torque:
- 11 N*m{ 112 kgf*cm , 8 ft.*lbf }
- NOTICE:
- Do not twist the curtain shield airbag assembly LH when installing it.
Attach the 4 claws and install the 4 bolts in the order shown in the illustration to install the curtain shield airbag assembly LH (arrows 11 through 18).
- Torque:
- 11 N*m{ 112 kgf*cm , 8 ft.*lbf }
- NOTICE:
- Do not twist the curtain shield airbag assembly LH when installing it.
Connect the connector.

- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
| 3. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH (for Double Cab) |
Attach the 9 claws and install the 9 bolts in the order shown in the illustration to install the curtain shield airbag assembly LH.


- Torque:
- 11 N*m{ 112 kgf*cm , 8 ft.*lbf }
- NOTICE:
- Do not twist the curtain shield airbag assembly LH when installing it.
Connect the connector.

- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
| 4. INSTALL ROOF HEADLINING ASSEMBLY |
for Single Cab:
(Click here).
for Extra Cab:
(Click here).
for Double Cab:
(Click here).
