REMOVAL
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for RHD and LHD vehicles.
| 1. REMOVE NO. 1 SWITCH HOLE BASE |
![]() ![]() |
Put protective tape around the No. 1 switch hole base.
Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 5 claws.
Disconnect the connectors and remove the No. 1 switch hole base.
| 2. REMOVE HEADLIGHT CLEANER SWITCH ASSEMBLY |
Detach the 2 claws and remove the headlight cleaner switch assembly.


