2014 Hilux · Service Manual BODY ELECTRICAL

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT HEADLIGHT CLEANER CONTROL RELAY

  1. E186708E03
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    6 (PB) - 4 (E)
    Battery voltage is not applied
    10 kΩ or higher
    Battery positive (+) → Terminal 3 (IG)
    Battery negative (-) → Terminal 5 (FEWA)
    Battery positive (+) → Terminal 3 (IG)
    Battery positive (+) → Terminal 2 (H)
    Battery negative (-) → Terminal 4 (E)
    Below 1 Ω for 0.8 to 0.9 seconds, then resistance increases by large amount
    Battery positive (+) → Terminal 1 (HDLO)
    Battery positive (+) → Terminal 3 (IG)
    Battery negative (-) → Terminal 5 (FRWA)

    If the result is not as specified, replace the headlight cleaner control relay.
    Text in Illustration 
    *a
    Component without harness connected
    (Headlight Cleaner Control Relay)

← COMPONENTS (from Jun 2011)REMOVAL (from Jun 2011) →