After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
3.
REMOVE FRONT DOOR SCUFF PLATE LH
Put protective tape around the front door scuff plate LH.
Text in Illustration
*1
Protective Tape
Using a moulding remover, detach the 4 clips and 8 claws and remove the front door scuff plate LH.
4.
REMOVE FRONT DOOR OPENING TRIM LH
5.
REMOVE LOWER QUARTER TRIM PANEL LH
Remove the bolt and disconnect the front seat outer belt floor anchor.
Detach the claw, 3 clips and 2 guides and remove the lower quarter trim panel LH.
6.
REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH
Disconnect the connector.
Remove the bolt and side airbag sensor assembly LH.