2014 Hilux · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013


1. INSTALL NO. 3 EXHAUST GAS TEMPERATURE SENSOR

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. Using a 14 mm union nut wrench, install the No. 3 exhaust gas temperature sensor.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).


2. INSTALL NO. 2 EXHAUST GAS TEMPERATURE SENSOR

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. Using a 14 mm union nut wrench, install the No. 2 exhaust gas temperature sensor.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

  1. A254445E01
    Attach the 5 clamps.
    Text in Illustration 
    *1
    Wire Harness
    *2
    Clamp

    HINT:
    Make sure that the part of the wire harness is as shown in the illustration.


3. INSTALL EXHAUST GAS TEMPERATURE SENSOR

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. Using a 14 mm union nut wrench, install the exhaust gas temperature sensor.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).


    HINT:
    A253547E01
    The sensor should be assembled within 20° of the prescribed position on either side.

    Text in Illustration 
    *a
    Top
    *b
    LH


4. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(Click here)
← INSTALLATION (Jun 2011 – Jul 2013)ON-VEHICLE INSPECTION (from Jun 2011) →