REMOVAL
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
| 3. DRAIN ENGINE COOLANT |
- CAUTION:
- Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Loosen the radiator drain cock plug.
- HINT:
- Collect the coolant in a container and dispose of it according to the regulations in your area.
Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.

Loosen the cylinder block drain cock plug.


| 4. REMOVE TURBINE OUTLET ELBOW |
| 5. REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY |
Remove the 2 bolts and injector holder.

Text in Illustration *1
Injector Holder
*2
No. 1 Nozzle Holder Clamp
*3
Exhaust Fuel Addition Injector
*4
E-Ring
*5
No. 3 Backup Ring
*6
O-Ring
*7
No. 2 Backup Ring
*8
No. 1 Backup Ring
*9
Gasket
Using a T40 "TORX" socket wrench, remove the screw, washer and No. 1 nozzle holder clamp.
Remove the exhaust fuel addition injector and gasket.
Remove the E-ring, O-ring and 3 backup rings from the exhaust fuel addition injector.
