2014 Hilux · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013


CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
E275626E02
  1. Disconnect the R21 and R23 radio and display receiver assembly connectors.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R23-3 (ACC) - R23-7 (GND)
    GR - BR
    ACC signal
    Ignition switch off
    Below 1 V
    Ignition switch ACC
    11 to 14 V
    R23-4 (B) - R23-7 (GND)
    L-Y - BR
    Battery
    Always
    11 to 14 V
    R23-7 (GND) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω
    R21-1 (IG+) - R23-7 (GND)
    P - BR
    IG signal
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the R21 and R23 radio and display receiver assembly connectors.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R28-12 (V+) - R28-24 (V-)
    W - R
    Display signal
    Ignition switch ON, shift lever in R
    Pulse generation (See waveform 1)
    Ignition switch ON, shift lever in R, screen blacked out by covering camera lens
    Pulse generation (See waveform 2)
    R28-11 (CA+) - R28-23 (CGND)
    B - Shielded
    Power source
    Ignition switch ACC
    5.5 to 7.05 V
    R28-23 (CGND) - Body ground
    Shielded - Body ground
    Shielding
    Always
    Below 1 V
    R21-2 (REV) - R23-7 (GND)
    R-Y - BR
    Reverse signal
    Ignition switch ON, shift lever in R
    7.5 to 14 V
    Ignition switch ON, shift lever not in R
    Below 1 V
    If the result is not as specified, the radio and display receiver assembly may have a malfunction.

  5. E159949E01
    Using an oscilloscope, check waveform 1.
    Measurement Condition 
    Item
    Content
    Terminal No. (Symbol)
    R28-12 (V+) - R28-24 (V-)
    Tool Setting
    0.2 V/DIV., 50 μs/DIV.
    Condition
    Ignition switch ON, shift lever in R

  6. E164781E01
    Using an oscilloscope, check waveform 2.
    Measurement Condition 
    Item
    Content
    Terminal No. (Symbol)
    R28-12 (V+) - R28-24 (V-)
    Tool Setting
    0.2 V/DIV., 50 μs/DIV.
    Condition
    Ignition switch ON, shift lever in R, screen blacked out by covering camera lens

← TERMINALS OF ECU (Jun 2011 – Jul 2013)DTC CHECK / CLEAR (from Aug 2013) →