REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. REMOVE NO. 2 ENGINE UNDER COVER |
| 2. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Wipe the oil pan and drain plug.
Install a new gasket and the oil pan drain plug.
- Torque:
- 34 N*m{ 347 kgf*cm , 25 ft.*lbf }
| 3. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY |
Disconnect the engine oil pressure switch connector.
Using a 24 mm deep socket wrench, remove the engine oil pressure switch from the oil cooler cover.
