REASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1. INSTALL BLOWER MOTOR WITH FAN SUB-ASSEMBLY |
w/o PTC Heater:

Disconnect the 2 connectors and detach the 2 clamps and wire harness.
w/ PTC Heater:
Disconnect the 4 connectors and detach the 3 clamps and wire harness.Text in Illustration *A
w/o PTC Heater
*B
w/ PTC Heater
Remove the 3 screws and blower motor with fan sub-assembly.

| 2. INSTALL BLOWER RESISTOR |
![]() ![]() |
Disconnect the connector.
Remove the 2 screws and blower resistor.
| 3. INSTALL CLEAN AIR FILTER |
Install the clean air filter.
Attach the claw to install the air filter case.
| 4. INSTALL AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY |
Attach the 3 claws to install the air inlet damper control cable sub-assembly.

