2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT NO. 1 VACUUM SWITCHING VALVE ASSEMBLY (for Swirl Control Valve)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    37 to 44 Ω
    1 - Body ground
    2 - Body ground
    20°C (68°F)
    10 kΩ or higher

    If the result is not as specified, replace the vacuum switching valve.

  1. G037162E03
    Check the operation according to the value(s) in the table below.
    Text in Illustration 
    *1
    Port E
    *2
    Filter
    V100135
    Airflow

    1. Check that air flows from port E to the filter.
      If the result is not as specified, replace the vacuum switching valve.

    2. A110309E04
      Apply battery voltage across the terminals.
      Text in Illustration 
      *1
      Port E
      *2
      Port F
      V100135
      Airflow

    3. Check that air flows from port E to port F.
      If the result is not as specified, replace the vacuum switching valve.

← REMOVAL (from Aug 2013)INSTALLATION (Jun 2011 – Jul 2012) →