Detach the 2 hooks in the order shown in the illustration and remove the front seat inner cushion shield LH.
5.
REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
Raise the reclining adjuster release handle LH to reveal the claw. Using a screwdriver, detach the claw and remove the reclining adjuster release handle LH.
HINT:
Tape the screwdriver tip before use.
Text in Illustration
*1
Protective Tape
6.
REMOVE FRONT SEAT CUSHION SHIELD LH
Remove the 2 screws.
Detach the 2 hooks in the order shown in the illustration, and then detach the guide and remove the front seat cushion shield LH.
Text in Illustration
*1
Hook
*2
Guide
7.
REMOVE SEATBACK SPRING LH
Remove the seatback spring LH.
8.
REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Detach the 3 front seat airbag wire harness clamps.
Remove the hog rings and fold back the separate type front seat cushion cover and rubber bands of the separate type front seatback cover.
for LHD, w/ Seat Heater System: Disconnect the front seatback heater assembly LH connector.
Remove the 4 bolts and separate type front seatback assembly.
9.
REMOVE SEPARATE TYPE FRONT SEATBACK COVER
Remove the hog rings and detach the 2 pieces of fastening tape.
Text in Illustration
*1
Fastening Tape
Pass the front seat airbag wire harness through the hole of the separate type front seatback cover, and then roll up the separate type front seatback cover.
Remove the hog rings and detach the 2 straps of the separate type front seatback cover, and then roll up the separate type front seatback cover.
Pass the strap of the separate type front seatback cover through the holes of the separate type front seatback pad.
Remove the nut and detach the separate type front seatback cover bracket.
Remove the hog rings and roll up the separate type front seatback cover.
Text in Illustration
*a
Front view of front seatback
*b
Rear view of front seatback
Detach the 4 claws and remove the 2 front seat headrest supports and separate type front seatback cover from the separate type front seatback pad.
10.
REMOVE FRONT SEATBACK HEATER ASSEMBLY LH
Cut off the tack pins which hold down the front seatback heater assembly LH, and then remove the front seatback heater assembly LH from the separate type front seatback cover.
NOTICE:
Be careful not to damage the separate type front seatback cover.