Apply protective tape around the front seat cushion shield.
Using a screwdriver, detach the 2 claws and remove the reclining power seat switch knob.
HINT:
Tape the screwdriver tip before use.
Text in Illustration
*1
Protective Tape
3.
REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
Apply protective tape around the front seat cushion shield.
Using a screwdriver, detach the 4 claws and remove the slide and vertical power seat switch knob.
HINT:
Tape the screwdriver tip before use.
Text in Illustration
*1
Protective Tape
4.
REMOVE FRONT SEAT CUSHION SHIELD LH
Remove the 2 screws.
Remove the 3 screws.
Detach the claw and guide.
Remove the front seat cushion shield RH.
5.
REMOVE FRONT POWER SEAT SWITCH LH
Remove the 3 screws.
Disconnect the connector and remove the front power seat switch RH.
6.
REMOVE FRONT SEAT INNER CUSHION SHIELD LH
Remove the screw.
Detach the claw and guide.
Pull the front seat inner cushion shield RH to detach the claw and remove the front seat inner cushion shield RH.
7.
REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
Disconnect the connector and detach the 3 clamps.
Roll up the front seat cushion cover LH.
Remove the nut and front seat inner belt assembly.
Remove the buckle cover.
8.
REMOVE FRONT SEAT CUSHION COVER WITH PAD
Remove the hog rings.
for LHD, w/ Seat Heater System:
Disconnect the 2 front seat cushion heater assembly LH connectors.
Detach the 4 front seat cushion heater assembly LH clamps.
Bend the 2 front seat cushion frame claws upward.
Detach the hooks and remove the front seat cushion cover with pad.
9.
REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Remove the hog rings and separate type front seat cushion cover from the separate type front seat cushion pad.
10.
REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH
Cut off the tack pins which hold down the front seat cushion heater assembly LH, and then remove the front seat cushion heater assembly LH from the separate type front seat cushion cover.
NOTICE:
Be careful not to damage the separate type front seat cushion cover.