2014 Hilux · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER
  1. Install the brake master cylinder reservoir strainer to the brake master cylinder reservoir assembly.


2. INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY
  1. Install the brake master cylinder reservoir filler cap assembly to the brake master cylinder reservoir assembly.


3. INSTALL BRAKE FLUID INFORMATION LABEL

4. INSTALL MASTER CYLINDER RESERVOIR GROMMET

  1. C236938E02
    Apply a light coat of lithium soap base glycol grease to 2 new master cylinder reservoir grommets.

  1. Install the 2 master cylinder reservoir grommets to the brake master cylinder reservoir assembly.


5. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
  1. Install the brake master cylinder reservoir assembly to the master cylinder sub-assembly.

  1. Mount the brake master cylinder sub-assembly in a vise.

    NOTICE:
    Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.

  1. Using a pin punch and hammer, install the master cylinder pin to the brake master cylinder reservoir.

← INSPECTION (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2013) →