2014 Hilux · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2013

CAUTION:
  1. The rear No. 1 seat inner belt assembly LH cannot be disconnected from the rear seat 3 point type belt assembly RH.
  2. When replacing the rear seat 3 point type belt assembly RH or rear No. 1 seat inner belt assembly LH, make sure to replace both with new ones.
  3. Make sure to connect the new rear seat 3 point type belt assembly RH and new rear No. 1 seat inner belt assembly LH.


1. REMOVE REAR SEAT HINGE COVER LH

B276874
  1. Pull the rear seat hinge cover LH to detach the 2 claws.

    Text in Illustration 
    V100135
    Pull
    V100136
    Pull Up

  1. Pull up the rear seat hinge cover LH to detach the guide and remove the rear seat hinge cover LH.


2. REMOVE REAR SEAT HINGE COVER RH

HINT:
Use the same procedures described for the LH side.


3. REMOVE REAR SEAT ASSEMBLY

  1. B360153E01
    Detach the fold seat stopper band button and pull the fold seat stopper band to release the seat cushion lock.
    Text in Illustration 
    *1
    Fold Seat Stopper Band Button
    *2
    Seat Cushion Rubber Band

  1. Pull the rear No. 1 seat inner belt RH through the seat cushion rubber band.

  1. Fold up the rear seat cushion assembly.

  1. B360146
    Remove the bolt and disconnect the rear No. 1 seat inner belt assembly LH.

  1. Return the rear seat cushion assembly to its original position.

  1. B360162E01
    Pull the rear No. 1 seat inner belt assembly LH through the seat cushion rubber band.
    Text in Illustration 
    *1
    Seat Cushion Rubber Band

  1. Fold up the rear seat cushion assembly.

  1. Attach the fold seat stopper band to the vehicle body and temporarily fix the rear seat cushion assembly in place.

  1. B360143E01
    Remove the 4 bolts.

  1. Detach the fold seat stopper band from the vehicle body.

  1. Lift up the seat in the direction indicated by the arrow to detach the 2 hooks and 2 guides. Then remove the rear seat assembly.

    Text in Illustration 
    *1
    Hook
    *2
    Guide

    NOTICE:
    Be careful not to damage the vehicle body.


4. REMOVE BACK PANEL TRIM

  1. B350371
    Using a moulding remover, detach the 3 claws and 2 guides and disconnect the cover from the back panel trim.

  1. B350372
    Using a clip remover, remove the 4 clips.

  1. Detach the 9 clips and remove the back panel trim.


5. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH

  1. B360274
    Remove the 2 bolts and disconnect the upper part of the rear seat 3 point type belt assembly RH.

  1. Remove the 2 bolts.

  1. Detach the 2 claws and remove the rear 3 point type belt assembly RH retractor


6. REMOVE SEAT BELT BRACKET

  1. B354358
    Remove the 2 bolts and seat belt bracket.

← COMPONENTS (from Aug 2013)INSPECTION (from Aug 2013) →