DISASSEMBLY
Removal / installation · Vehicles built from Aug 2013
| 1. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY |
Remove the screw.
Remove the brake master cylinder reservoir from the brake master cylinder sub-assembly.
| 2. REMOVE MASTER CYLINDER RESERVOIR GROMMET |
Remove the 2 master cylinder reservoir grommets from the brake master cylinder reservoir assembly.
| 3. REMOVE BRAKE FLUID INFORMATION LABEL |
| 4. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY |
Remove the brake master cylinder reservoir filler cap assembly from the brake master cylinder reservoir assembly.
| 5. REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER |
Remove the brake master cylinder reservoir strainer from the brake master cylinder reservoir assembly.
| 6. REMOVE BRAKE MASTER CYLINDER KIT |
Push in the piston and remove the snap ring using snap ring pliers.

Push in the piston and remove the piston stopper bolt and gasket.

Remove the No. 1 piston from the master cylinder body by pulling it straight out.
- NOTICE:
- Do not scratch the inside of the cylinder body.
Tap the flanged part against wooden blocks until the end of the No.2 piston comes out. When the end of the No. 2 piston comes out, pull the No. 2 piston straight out of the master cylinder body.

- NOTICE:
- Do not scratch the inside of the cylinder body.
