Home › Drivetrain › VF2A TRANSFER / 4WD / AWD › FOUR WHEEL DRIVE CONTROL SYSTEM
NM1840EF _52 Drivetrain _010347 VF2A TRANSFER / 4WD / AWD _0055277 FOUR WHEEL DRIVE CONTROL SYSTEM GE GENERAL F

VF2A TRANSFER / 4WD / AWD  FOUR WHEEL DRIVE CONTROL SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

A compact and lightweight part-time 2-speed VF2A transfer is used on the 4WD models.


b.

An Automatic Disconnecting Differential (A.D.D.) shift actuator is used on the models with A.D.D shift actuator. The 4WD control ECU operates the A.D.D. shift actuator in order to connect and disconnect the front drive shaft and the front differential in conjunction with the 2WD-4WD switching operation of the transfer shift lever.


c.

A manual operation type 4WD system is used. The optimal drive mode is selected from 3 drive modes (H2, H4 and L4) in accordance with road surface conditions by operating the transfer shift lever, thus enabling a drive that makes optimal use of drive torque performance.



SPECIFICATION


Drive Type Part-time
Transfer Gear Ratio High 1.000
Low 2.566
Reduction Gear Type Single Pinion Planetary
Oil Capacity 1.0 Liters (1.1 US qts, 0.9 Imp. qts)
Oil Viscosity SAE 75W-90
Oil Grade API GL-3
Weight (Reference)* 31.5 kg (69.4 lb)

HINT:

*: Weight shows the figure with the fluid fully filled.



MAIN FEATURES


a.

Drive Mode Features

Drive Mode Transfer Gear Ratio Drive Type Features
H2 High 2WD This is used for normal driving on dry hard-surfaced roads. This mode gives greater economy, the quietest ride and the least wear.
H4 High 4WD This is used for driving only on tracks that permit the tires to slide, such as off-road, icy or snow-covered roads. This mode provides greater traction than 2WD.
L4 Low 4WD This is used for maximum power and traction. L4 is used for climbing or descending steep hills, off-road driving, and hard pulling in sand, mud or deep snow.