Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › BLOCKING SYSTEM › from 2012.01
NM1840EF _58 Vehicle Interior _010365 THEFT DETERRENT / KEYLESS ENTRY _0055301 BLOCKING SYSTEM CO CONTROL F

THEFT DETERRENT / KEYLESS ENTRY  BLOCKING SYSTEM  CONTROL  BLOCKING CONTROL  


FUNCTION OF MAIN COMPONENTS


a.

The main components of the blocking system have the following functions:

Component Function
DCM
·

Cancels or connects the communication between the transponder key ECU and ECM.

·

Receives signals from the GPS antenna and telephone antenna.

·

Transmits a signal to the telephone antenna.


Auxiliary Battery Provides power to the DCM when the power supply from the vehicle battery is cut off or has deteriorated.
Integration Antenna Assembly GPS Antenna Receives the signals from the GPS satellites and transmits the vehicle position signal to the DCM.
Telephone Antenna Sends and receives information to and from the call center through the Global System for Mobile communications (GSM), and transmits received information to the DCM.



FUNCTION


a.

The blocking system provides the functions in the table below:

Function Outline
Localization Conducts vehicle localization by transmitting vehicle location data received from GPS satellites to the call center via the DCM.
Blocking
·

Once the user has informed the call center of a vehicle theft, the call center will transmit a blocking signal to the vehicle. Once the DCM has received the blocking signal, it will activate the blocking. Communication between the transponder key ECU and ECM is canceled, thus preventing the engine from starting.

·

Using information about the vehicle's location received from the GPS satellites, when the vehicle's movement is detected while the ignition switch is off, an abnormal operation notification is transmitted from the DCM to the call center.



HINT:
·

The user can cancel the blocking function by contacting the call center.

·

While the blocking function is active, the engine cannot be started even though the engine immobiliser function has been unset. Re-start the engine after the blocking function has been canceled.





DIAGNOSIS


a.

The 5-digit DTC can be read by connecting an intelligent tester II to the DLC3. For details, refer to the Repair Manual.