CONSTRUCTION
A water-cooled type EGR cooler is used in the EGR pipe sub-assembly between the cylinder head and EGR valve. In the water-cooled type EGR cooler, engine coolant flows through the six-layered gas passage to cool down the EGR gas.
A No. 2 EGR valve assembly (EGR cooler bypass switching valve) is used. If EGR gas is cooled down in the EGR cooler with light engine load and low engine coolant temperature, compression air temperature decreases. To prevent this, the EGR gas passage is switched by the EGR cooler bypass switching valve. The EGR passage is switched in 2 stages.
| *1 | EGR Pipe Sub-assembly | *2 | Engine Coolant Inlet |
| *3 | Actuator for EGR Cooler Bypass Switching Valve | *4 | No. 2 EGR Valve Assembly |
| *5 | EGR Cooler Bypass Switching Valve | *6 | Engine Coolant Outlet |
| *7 | Bypass Passage | *8 | EGR Cooler |
| *9 | EGR Gas Passage | *10 | Engine Coolant Passage |
| *a | View from Upper Side | *b | Cross Section |
|
EGR Gas |
|
EGR Gas (through EGR Cooler) |
|
EGR Gas (through Bypass Passage) | - | - |