Home › Engine / Hybrid System › 2TR-FBE EMISSION CONTROL › EMISSION CONTROL SYSTEM
NM1840EF _51 Engine / Hybrid System _010311 2TR-FBE EMISSION CONTROL _0055236 EMISSION CONTROL SYSTEM CO CONTROL F

2TR-FBE EMISSION CONTROL  EMISSION CONTROL SYSTEM  CONTROL  EMISSION CONTROL  


FUNCTION OF MAIN COMPONENTS


a.

The main components of the emission control system are as follows:

Component Function
Exhaust Emission System ECM Determines an optimal fuel injection volume based on the signals from various sensors.
TWC Reduces CO, HC and NOx in the exhaust gas.
Oxygen Sensor Detects the oxygen concentration in the exhaust emissions by measuring the electromotive force generated in the sensor itself. For details, see the 2TR-FBE Engine Control.
Air Fuel Ratio Sensor
Air Injection System Air Pump Uses a built-in DC motor to supply air to the air switching valve.
Air Switching Valve Introduces air that is pumped by the air pump into the exhaust manifold.
Air Injection Control Driver
·

Activated by the ECM, the air injection control driver actuates the electric air pump and the air switching valve.

·

Detects an input-output circuit failure at the air injection control driver and transmits it to the ECM.


ECM
·

Controls the air injection system in accordance with signals from the crankshaft position sensor, engine coolant temperature sensor and intake mass air flow meter sub-assembly.

·

Receives a failure detection signal from the air injection control driver and stores a corresponding DTC in memory.


Evaporative Emission Control ECM Sends signals to the VSV (for EVAP) to control the purge flow.
Charcoal Canister Sub-assembly Contains activated charcoal to absorb the fuel vapor created in the fuel tank.
VSV (for EVAP) Opens in accordance with the signals from the ECM when the system is purging, in order to send the fuel vapor that was absorbed by the charcoal canister into the intake manifold.