CONSTRUCTION
This automatic transmission uses an input speed sensor (for NCO signal) and an output speed sensor (for SP2 signal). Thus, the ECM can detect the timing of the shifting of the gears and appropriately control the engine torque and hydraulic pressure in response to various conditions.
These speed sensors are the pick-up coil type.
The input speed sensor detects the input speed of the transmission. The overdrive direct clutch drum is used as the timing rotor for this sensor.
The output speed sensor detects the speed of the output shaft.
| *1 | Overdrive Direct Clutch Drum | *2 | Input Speed Sensor |
| *3 | Output Speed Sensor | *4 | Output Shaft |