CONSTRUCTION
The shift solenoid valve DSL (S1) and shift solenoid valve S4 (SR) are 3-way solenoid valves.
The No. 3 transmission solenoid assembly (S2) uses a 2-way solenoid valve.
A filter is provided at the tip of the solenoid valve to further improve operational reliability.
| *1 | Filter | - | - |
| *a | Off Condition | *b | On Condition |
|
Line Pressure |
|
Control Pressure |
|
Drain | - | - |
| *1 | Filter | - | - |
| *a | Off Condition | *b | On Condition |
|
Line Pressure |
|
Control Pressure |
| *1 | Filter | - | - |
| *a | Off Condition | *b | On Condition |
|
Line Pressure |
|
Control Pressure |
|
Drain | - | - |
In order to provide a hydraulic pressure that is proportional to the current that flows to the solenoid coil, the shift solenoid valves SL1 and SL2 linearly control the clutch pressure based on the signals they receive from the ECM or TCM.
In order to provide a hydraulic pressure that is proportional to the current that flows to the solenoid coil, the line pressure control solenoid assembly (SLT) linearly controls the line pressure based on the signals it receives from the ECM or TCM.
In order to provide a hydraulic pressure that is proportional to the current that flows to the solenoid coil, the lock-up control solenoid assembly (SLU) linearly controls the lock-up clutch engagement pressure based on the signals it receives from the ECM or TCM.
| Shift Solenoid Valve | Function |
|---|---|
| S1 | Switches the 2-3 shift valve. |
| S2 | Switches the 1-2 shift valve and the 3-4 shift valve. |
| SR | Switches the clutch apply control valve. |
| SL1 | ·
C1 clutch pressure control ·
Accumulator back pressure control |
| SL2 | B1, B2 and B4 brake pressure control |
| SLT | ·
Line pressure control ·
Accumulator back pressure control |
| SLU | ·
Lock-up clutch pressure control ·
Accumulator back pressure control |