Home › Drivetrain › VF2A TRANSFER / 4WD / AWD › FOUR WHEEL DRIVE CONTROL SYSTEM
NM1840EF _52 Drivetrain _010347 VF2A TRANSFER / 4WD / AWD _0055277 FOUR WHEEL DRIVE CONTROL SYSTEM CO CONTROL F

VF2A TRANSFER / 4WD / AWD  FOUR WHEEL DRIVE CONTROL SYSTEM  CONTROL  FOUR WHEEL DRIVE CONTROL  


FUNCTION OF MAIN COMPONENTS


Models with A.D.D. Shift Actuator
Component Function
A.D.D. Shift Actuator Assembly A.D.D. Shift Motor Switches the engagement of the front drive shaft and the front differential between lock and free in accordance with signals from the 4WD control ECU.
A.D.D. Motor Limit Switch Detects the position of the A.D.D. shift motor and transmits a signal to the 4WD control ECU.
A.D.D. Position Switch Detects the lock position of the engagement of the front drive shaft and the front differential and transmits a signal to the 4WD control ECU and so on.
Transfer Indicator Switch (4WD Position) Detects the 4WD position of the transfer shift lever, transmits a signal to the 4WD control ECU.
4WD Control ECU Controls the A.D.D. shift motor in response to a signal from the transfer indicator switch (4WD position).
Skid Control ECU*1 Detects the drive mode signal.
ECM Detects the drive mode signal.*2
TCM*3 Transmits a shift position signal to the ECM via CAN.
Combination Meter Assembly 4WD Indicator Light
·

Illuminates when the A.D.D. shift actuator is conducting 4WD detection.

·

Blinks when the switching conditions of the A.D.D. shift actuator assembly are not met.



*1: Models with brake control system

*2: Models with gasoline engine

*3: Models with diesel engine and automatic transmission



OPERATING CONDITION


a.

On the models with A.D.D shift actuator, when the vehicle speed is below approximately 100 km/h (62 mph), 2WD-4WD switching is available while the vehicle is running.


b.

On the models with manual transmission, the transfer gear ratio can be switched from high to low when the clutch pedal is depressed without depressing the accelerator pedal while the vehicle is either stopped or traveling at 8 km/h (5 mph) or less. In addition, shifting from low gear to high gear is possible while the clutch pedal is depressed.


c.

On the models with automatic transmission, the transfer gear ratio can be switched between high and low only when the vehicle is stationary and the shift lever is in N.


d.

TRC function in the brake control system may be stopped, depending on the drive mode. For details, see the Brake Control/Dynamic Control Systems section.