CONSTRUCTION
A transfer low planetary gear assembly is used on the planetary gear unit to switch the transfer gear ratio between high and low.
The transfer low planetary gear assembly consists of a planetary sun gear, 4 planetary pinion gears, planetary ring gear and planetary carrier.
The planetary sun gear is integrated with the transfer input shaft.
4 planetary pinion gears are fitted to the planetary carrier. Each pinion gear shaft is fixed to the planetary carrier. A transfer low planetary spline piece is fitted to the rear of the planetary carrier.
The planetary ring gear is fixed to the front transfer case and its internal teeth mesh with the planetary pinion gears.
In this planetary gear unit, the power transmission route is switched in accordance with the movement of the transfer high and low clutch sleeve. The input power from the transfer input shaft is transmitted to the transfer rear output shaft via the transfer high and low clutch sleeve and the transfer high and low clutch hub.
| *1 | Transfer Input Shaft | *2 | Pinion Shaft |
| *3 | Planetary Sun Gear | *4 | Planetary Pinion Gear |
| *5 | Transfer High and Low Clutch Hub | *6 | Transfer High and Low Clutch Sleeve |
| *7 | Transfer Rear Output Shaft | *8 | Transfer Low Planetary Spline Piece |
| *9 | Planetary Carrier | *10 | Planetary Ring Gear |
OPERATION
High-low Switching of Transfer Gear Ratio
High Position
In the high position, the splines at the rear of the transfer input shaft mesh with the internal gear teeth of the high and low clutch sleeve.
Also, the high and low clutch sleeve is meshed to the transfer rear output shaft via the high and low clutch hub.
The rotation of the input shaft is transmitted to the high and low clutch sleeve, the high and low clutch hub, and the transfer rear output shaft.
| *1 | Planetary Sun Gear | *2 | Transfer Input Shaft |
| *3 | Transfer Rear Output Shaft | *4 | Transfer High and Low Clutch Sleeve |
| *5 | Transfer Low Planetary Spline Piece | *6 | Planetary Carrier (Planetary Pinion Gear Shaft) |
| *7 | Planetary Ring Gear | *8 | Planetary Pinion Gear |
|
Drive Torque |
|
Movement |
Low Position
In the low position, the external teeth of the high and low clutch sleeve are meshed with the transfer low planetary spline piece.
The rotation of the input shaft is transmitted in a reduced form to the planetary sun gear, planetary pinion gear, planetary pinion gear shaft, planetary carrier, transfer low planetary spline piece, high and low clutch sleeve, high and low clutch hub, and transfer rear output shaft.
| *1 | Planetary Sun Gear | *2 | Transfer Input Shaft |
| *3 | Transfer Rear Output Shaft | *4 | Transfer High and Low Clutch Sleeve |
| *5 | Transfer Low Planetary Spline Piece | *6 | Planetary Carrier (Planetary Pinion Gear Shaft) |
| *7 | Planetary Ring Gear | *8 | Planetary Pinion Gear |
|
Drive Torque |
|
Movement |