OPERATION
On the models compliant with EURO 5 emission regulations, glow plug control carries out the following controls:
When the ignition switch is turned from off to ON, the ECM sends a signal to the glow plug controller. Based on this signal, the glow plug controller heats the glow plug assemblies rapidly. At this moment, the glow indicator light in the combination meter is illuminated to inform the driver that the glow plug assemblies are being heated.
When the engine starts and the starter signal is off, after-glow control is conducted.
In accordance with signals from the ECM, the glow plug controller independently applies current via the glow plug assembly in each cylinder to control the temperature of each cylinder independently.
When the glow plug controller detects a malfunction in the glow circuit, it sends a diagnostic signal to the ECM.
While the catalyst support control is in operation, the ECM sends a signal to the glow plug controller to heat the glow plug assembly. For details of catalyst support control, see the 2KD-FTV EMISSION CONTROL section.
[EMISSION CONTROL SYSTEM > CATALYST SUPPORT CONTROLEngine / Hybrid System>2KD-FTV EMISSION CONTROL>EMISSION CONTROL SYSTEM>CATALYST SUPPORT CONTROL]
Except on the models compliant with EURO 5 emission regulations, glow plug control carries out the following controls:
When the ignition switch is turned from off to ON, the ECM operates the glow plug relay to heat the glow plug assemblies rapidly. At that moment, the glow indicator light in the combination meter assembly is illuminated to inform the driver that the glow plug assemblies are being heated.
When the engine starts and the starter signal is off, after-glow control is conducted. When the temperature of the glow plug assembly reaches a predetermined level during after-glow control, it is maintained at a nearly constant level using the self-temperature-controlling function of the glow plug assembly.