CONSTRUCTION
Models Compliant with EURO 5 and Tier 1.5 Emission Regulations
A DC motor type electric EGR control valve assembly is used. The placement of the electric EGR control valve assembly at the intersection between the intake passage and EGR bypass facilitates the uniform distribution of EGR gas and intake air.
An EGR valve position sensor is provided in the electric EGR control valve assembly. This sensor enables EGR valve control at a higher level of precision by detecting the opening angle of the EGR valve.
| *1 | Electric EGR Control Valve Assembly | *2 | EGR Valve Position Sensor |
| *3 | DC Motor Portion | *4 | EGR Valve |
| *5 | Diesel Throttle Body Assembly | - | - |
| *a | View from Back Side | - | - |
|
Intake Air |
|
EGR Gas |
|
Front | - | - |
Models Compliant with EURO 4, EURO 3, EURO 2 and EURO 1 Emission Regulations
A vacuum actuated type electric EGR control valve assembly is used.
The electric EGR control valve assembly is provided midstream in the intake air passage. By cooling the electric EGR control valve assembly in this manner, a greater volume of exhaust gas can be processed.
On the models compliant with EURO 4 emission regulations, an EGR valve position sensor is provided in the electric EGR control valve assembly in order to directly measure the actual amount of the valve opening. This measurement is then input into the ECM in order to improve the precision of EGR control.
| *1 | Electric EGR Control Valve Assembly | *2 | Vacuum Port |
| *3 | EGR Valve | *4 | Air Port |
| *5 | EGR Valve Position Sensor | - | - |
| *a | From Diesel Throttle Body | *b | To Intake Manifold |
| *c | From EGR Pipe Sub-assembly | - | - |
|
Intake Air |
|
EGR Gas |
| *1 | Electric EGR Control Valve Assembly | *2 | Vacuum Port |
| *3 | EGR Valve | *4 | Air Port |
| *a | From Diesel Throttle Body | *b | To Intake Manifold |
| *c | From EGR Pipe Sub-assembly | - | - |
|
Intake Air |
|
EGR Gas |