CONSTRUCTION
The cab mount area uses a collar construction to improve the rigidity of its force application point and minimize the transmission of vibration to the body.
| *1 | No. 1 Cab Mount | *2 | No. 2 Cab Mount |
| *3 | No. 3 Cab Mount (Single Cab Models) | *4 | No. 3 Cab Mount (Double Cab Models) |
| *5 | Frame Sub-assembly | *6 | Collar |
| *7 | Body Shell | *8 | Cab Mounting Cushion Holder |
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | C - C Cross Section | *d | D - D Cross Section |
An asphalt sheet is used to reduce engine and road noise.
| *A | Double Cab Models | - | - |
| *1 | Asphalt Sheet (Dash Panel Insulator Sheet No. 1) | *2 | Asphalt Sheet (Front Floor Silencer Sheet) |
A hood insulator is provided on the rear of the hood panel on the models with diesel engine and on GGN25L-PRASKL. This achieves excellent sound insulation performance.
| *A | Models without Intercooler | *B | Models with Intercooler |
| *1 | Hood Insulator | - | - |
A dash panel insulator outer is provided on models with diesel engine. This reduces the engine noise leaking into and out of the cabin.
| *1 | Dash Panel Insulator Outer | - | - |
A dash panel insulator is provided. This insulates and absorbs the engine noise to reduce the engine noise leaking into the cabin.
| *1 | Dash Panel Insulator | - | - |
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | Engine Compartment Side | *d | Cabin Side |
| *e | Felt | *f | Adhesive |
| *g | EPDM | - | - |
Polyurethane foam and sparkling material are applied to the roof panel and pillars to reduce wind and road noise.
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | C - C Cross Section | *d | D - D Cross Section |
| *e | E - E Cross Section | - | - |
|
Polyurethane Foam |
|
Sparkling Material |
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | C - C Cross Section | *d | D - D Cross Section |
| *e | E - E Cross Section | *f | F - F Cross Section |
| *g | G - G Cross Section | *h | H - H Cross Section |
| *i | I - I Cross Section | *j | J - J Cross Section |
| *k | K - K Cross Section | *l | L - L Cross Section |
|
Polyurethane Foam |
|
Sparkling Material |
Reinforcements have been optimally allocated to the back panel area of the single cab and double cab models to minimize droning noise. On all models, a stamped shape has been added to the deck panel on the cabin side to prevent it from resonating with the back panel and minimize droning noise.
| *A | Double Cab Models | *B | Single Cab Models |
| *C | Models with Deck Panel | - | - |
| *1 | Reinforcement | - | - |
Wind noise has been reduced through the use of the following constructions:
The installation angle of the front windshield has been optimized to ensure smooth airflow.
The clearance between the door sash and the roof, and the clearance between the rear door and the deck have been reduced compared to the conventional model.
The outside rear view mirror has been optimally shaped.
| *a | A - A Cross Section | *b | B - B Cross Section |
|
Airflow | - | - |