Home › General › SPECIFICATIONS › 2KD-FTV BATTERY / CHARGING
RM1840EF _V1 General _009566 SPECIFICATIONS _0052012 2KD-FTV BATTERY / CHARGING F

SPECIFICATIONS  2KD-FTV BATTERY / CHARGING  SERVICE DATA  


Generator Rated output 12 V 80 A
Voltage regulator Regulating voltage 13.2 to 14.0 V
Battery Standard specific gravity 1.25 to 1.29 at 20°C (68°F)
Charging circuit without load Standard amperage 10 A or less
Standard voltage 13.2 to 14.8 V
(When engine speed at 2000 rpm)
Charging circuit with load Standard amperage 30 A or more
for Denso made Generator rotor Slip rings Standard resistance 1.85 to 2.25 Ω at 20°C (68°F)
Slip ring - rotor Standard resistance 10 kΩ or higher
Slip ring Standard diameter 14.2 to 14.4 mm (0.559 to 0.567 in.)
Minimum diameter 14.0 mm (0.551 in.)
Generator brush holder assembly Brush length Standard exposed length 9.5 to 11.5 mm (0.374 to 0.453 in.)
Minimum exposed length 4.5 mm (0.177 in.)
for Bosch made Generator rotor Standard resistance Slip rings 1.8 to 2.8 Ω 20°C (68°F)
Slip ring - rotor Standard resistance 10 kΩ or higher
Slip ring Standard diameter 15.3 to 15.5 mm (0.602 to 0.610 in.)
Minimum diameter 14.9 mm (0.587 in.)
Generator regulator assembly Brush length Standard exposed length 13.2 mm (0.520 in.)
Minimum exposed length 6.0 mm (0.236 in.)
Generator starter sub-assembly with rectifier Rectifier terminals Standard resistance Below 1Ω