Home › General › SPECIFICATIONS › 2KD-FTV BATTERY / CHARGING
RM1840EF _V1 General _009566 SPECIFICATIONS _0052012 2KD-FTV BATTERY / CHARGING F

SPECIFICATIONS  2KD-FTV BATTERY / CHARGING  TORQUE SPECIFICATIONS  


for Denso made
Part Tightened N*m kgf*cm ft.*lbf in.*lbf
Generator x V-ribbed belt tensioner Bolt A 62 632 46
Generator x V-ribbed belt tensioner Bolt B 25 255 18
Generator wire x Generator 9.8 100 87
Retainer x Generator drive end frame 2.3 23 20
Generator coil x Generator drive end frame 5.9 60 52
Generator brush holder x Generator coil 1.8 18 16
Generator rear end cover x Generator coil 4.6 47 41
Generator pulley with clutch x Generator rotor 111 1132 82

for Bosch made
Part Tightened N*m kgf*cm ft.*lbf in.*lbf
Generator x V-ribbed belt tensioner Bolt A 62 632 46
Generator x V-ribbed belt tensioner Bolt B 25 255 18
Generator wire x Generator 9.8 100 87
Generator pulley with clutch x Generator assembly 80 816 59
Generator regulator assembly x Generator stator sub-assembly with rectifier for Screw A 2.5 25 22
Generator regulator assembly x Generator stator sub-assembly with rectifier for Screw B 1.2 12 11
Generator stator sub-assembly with rectifier x Drive end frame 4.3 44 38
Generator rear end cover x Generator stator sub-assembly with rectifier for Nut A 19 194 14
Generator rear end cover x Generator stator sub-assembly with rectifier for Nut B 12 122 9
Generator rear end cover x Generator stator sub-assembly with rectifier for screw 2.8 29 25