Home › Engine / Hybrid System › 2KD-FTV ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › from 2012.10
RM1840EF _51 Engine / Hybrid System _009568 2KD-FTV ENGINE CONTROL _0052057 CRANKSHAFT POSITION SENSOR A

2KD-FTV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.


b.

Install the crankshaft position sensor with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)


c.

Install the 4 clips and connect the crankshaft position sensor connector.

NOTICE:

Insert the crankshaft position sensor wire harness into the protrusions of the timing gear cover.



Hide 2.INSTALL NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)

Hide 3.INSTALL NO. 1 ENGINE UNDER COVER (for 4WD and Pre-Runner)