Home › Engine / Hybrid System › 2KD-FTV ENGINE CONTROL › ACCELERATOR PEDAL
RM1840EF _51 Engine / Hybrid System _009568 2KD-FTV ENGINE CONTROL _0052061 ACCELERATOR PEDAL G

2KD-FTV ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT ACCELERATOR PEDAL SENSOR

a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sens. No.1 Volt % and Accel Sens. No.2 Volt %.

Powertrain > Engine > Data List
Tester Display
Accel Sens. No.1 Volt %
Accel Sens. No.2 Volt %
50003 61 75,76

e.

Operate the accelerator pedal rod and check that the "Accel Sens. No.1 Volt %" and "Accel Sens. No.2 Volt %" values are within the specification.

If the result is not as specified, refer to DTC P2120 (See page Engine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM(w/ EGR Cooler)>P2120).