Home › Engine / Hybrid System › 2KD-FTV ENGINE CONTROL › INTAKE AIR TEMPERATURE SENSOR(w/o DPF)
RM1840EF _51 Engine / Hybrid System _009568 2KD-FTV ENGINE CONTROL _0052063 INTAKE AIR TEMPERATURE SENSOR(w/o DPF) A

2KD-FTV ENGINE CONTROL  INTAKE AIR TEMPERATURE SENSOR(w/o DPF)  REMOVAL  


PROCEDURE

Hide 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Intercooler)

Hide 2.REMOVE INTAKE AIR TEMPERATURE SENSOR

a.

Disconnect the intake air temperature sensor connector.

A260806
0.052,0.052 0.417,0.229 0.365,0.177 10 *A 3.865,0.052 4.188,0.229 0.323,0.177 10 *B
*A w/ Intercooler *B w/o Mass Air Flow Meter



b.

w/ Intercooler:

Using a 22 mm deep socket wrench, remove the intake air temperature sensor.

HINT:

Replace the intake air temperature sensor if it is deformed, cracked or malfunctioning. It is not necessary to replace the intake air temperature sensor each time the intercooler is replaced.



c.

w/o Mass Air Flow Meter:

Remove the intake air temperature sensor.