Home › Engine / Hybrid System › 2KD-FTV ENGINE CONTROL › ECD SYSTEM(w/ EGR Cooler) › from 2012.10
RM1840EF _51 Engine / Hybrid System _009568 2KD-FTV ENGINE CONTROL _0052067 ECD SYSTEM(w/ EGR Cooler) D

2KD-FTV ENGINE CONTROL  ECD SYSTEM(w/ EGR Cooler)  DTC CHECK / CLEAR  


NOTICE:

When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data stored in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data.


HINT:
·

DTCs which are stored in the ECM can be output to the intelligent tester. The intelligent tester can output current and pending DTCs.

·

Some DTCs are not stored if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.



CHECK DTC


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC.

Powertrain > Engine > Trouble Codes
50001 61

e.

Check the DTCs and freeze frame data, and then write them down.




CLEAR DTC


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.

Powertrain > Engine > Clear DTCs
50002 61

e.

Press the YES button.



CLEAR DTC (Without using Intelligent Tester)


a.

Perform either one of the following operations.

i.

Disconnect the cable from the negative (-) battery terminal for more than 1 minute.


ii.
A159237
1.865,2.708 2.417,2.479 false 2.469,2.385 2.771,2.604 0.302,0.219 10 false *2 0.281,0.323 0.563,0.531 0.281,0.208 10 false *1
*1 Engine Room Relay Block and Junction Block Assembly
*2 EFI Fuse


Remove the EFI fuse from the engine room relay block and junction block assembly for more than 1 minute.