Home › Engine / Hybrid System › 2KD-FTV ENGINE CONTROL › ECD SYSTEM(w/ EGR Cooler)
RM1840EF _51 Engine / Hybrid System _009568 2KD-FTV ENGINE CONTROL _0052067 ECD SYSTEM(w/ EGR Cooler) D

2KD-FTV ENGINE CONTROL  ECD SYSTEM(w/ EGR Cooler)  CHECK MODE PROCEDURE  


HINT:

Intelligent tester only:

Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected by normal mode.


NOTICE:

All the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from on or off while in check mode. Before changing modes, always check and make a note of any DTCs and freeze frame data.


CHECK MODE PROCEDURE (Using Intelligent Tester)


a.

Check that the following conditions are met:

i.

Battery positive voltage is 11 V or higher.


ii.

Throttle valve is fully closed.


iii.

Transmission is in neutral.


iv.

A/C is switched off.



b.

Turn the ignition switch off.


c.

Connect the intelligent tester to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the tester on.


f.

Enter the following menus: Utility / Check Mode.

Powertrain > Engine > Utility
Tester Display
Check Mode
50005 61 1

g.

Switch the ECM from normal mode to check mode.


h.
A208457
0.073,0.802 0.438,1.042 0.365,0.24 10 false ON 0.073,1.365 0.49,1.594 0.417,0.229 10 false OFF 2.021,0.427 3.042,0.688 1.021,0.26 10 false 0.13 seconds 1.917,1.823 2.906,2.052 0.99,0.229 10 false 0.13 seconds

Make sure the MIL flashes as shown in the illustration.


i.

Start the engine.


j.

Make sure the MIL turns off.


k.

Simulate the conditions of the malfunction described by the customer.


l.

Check for DTCs and freeze frame data using the tester.

Powertrain > Engine > Trouble Codes
50001 61

m.

After checking for DTCs, inspect the applicable circuits.