Home › Engine / Hybrid System › 2KD-FTV ENGINE CONTROL › MASS AIR FLOW METER(w/ DPF) › from 2012.04
RM1840EF _51 Engine / Hybrid System _009568 2KD-FTV ENGINE CONTROL _0052070 MASS AIR FLOW METER(w/ DPF) G

2KD-FTV ENGINE CONTROL  MASS AIR FLOW METER(w/ DPF)  INSPECTION  


PROCEDURE

Hide 1.PERFORM AIR BLOWING

a.
A260801

Intermittently air blow the air flow meter entrance hole with a pressure of approximately 400 to 1000 kPa (4 to 10 kgf/cm2, 60 to 140 psi) for 30 seconds.

NOTICE:

Do not let the tip of the air gun nozzle touch to the air flow meter, and do not insert the tip of the air gun nozzle into the air flow meter entrance hole.



Hide 2.INSPECT MASS AIR FLOW METER

a.
A222552
1.875,2.49 2.229,2.49 false 2.302,2.406 2.604,2.604 0.302,0.198 10 false *1
*1 Platinum Hot Wire (Heater)


Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.

OK:

There is no foreign matter.


If the result is not as specified, replace the mass air flow meter.