Home › Engine / Hybrid System › 2KD-FTV ENGINE CONTROL › AIR FUEL RATIO SENSOR(w/ DPF) › from 2012.04
RM1840EF _51 Engine / Hybrid System _009568 2KD-FTV ENGINE CONTROL _0052073 AIR FUEL RATIO SENSOR(w/ DPF) A

2KD-FTV ENGINE CONTROL  AIR FUEL RATIO SENSOR(w/ DPF)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL AIR FUEL RATIO SENSOR

a.
A253515
1.646,1.302 2.094,1.615 2.094,1.615 2.188,1.615 false 2.219,1.531 2.542,1.688 0.323,0.156 10 false SST 0.281,1.656 0.5,1.823 0.219,0.167 10 true *1
*1 Fulcrum Length


Using SST, install the air fuel ratio sensor to the front exhaust pipe.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




b.

Connect the air fuel ratio sensor connector.


c.

for 2WD:

Attach the clamp.


Hide 2. PERFORM AIR FUEL RATIO SENSOR COMPENSATION RESET