Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR(w/ Secondary Air Injection System)
RM1840EF _51 Engine / Hybrid System _009569 2TR-FE ENGINE CONTROL _0052074 AIR FUEL RATIO SENSOR(w/ Secondary Air Injection System) A

2TR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR(w/ Secondary Air Injection System)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

a.
G039121
2.083,0.25 2,0.25 2,0.25 1.573,0.813 false 2.146,0.177 2.552,0.406 0.406,0.229 10 SST 2.438,1.698 2.708,1.927 0.271,0.229 10 *1
*1 Fulcrum Length


Using SST, install the air fuel ratio sensor.

SST
09224-00010  

Torque:
for use without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
for use with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




b.

Attach the 3 wire harness clamps to the vehicle body.


c.

Connect the air fuel ratio sensor connector.