Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR(w/ Secondary Air Injection System)
RM1840EF _51 Engine / Hybrid System _009569 2TR-FE ENGINE CONTROL _0052075 HEATED OXYGEN SENSOR(w/ Secondary Air Injection System) G

2TR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR(w/ Secondary Air Injection System)  INSPECTION  


PROCEDURE

Hide 1.INSPECT HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

a.

Check the resistance.

i.
A112088
1.26,0.76 0.771,0.76 false 2.667,0.76 2.188,0.76 false 0.771,1.667 0.896,1.667 0.896,1.667 1.271,1.448 false 0.5,0.677 0.781,0.865 0.281,0.188 10 false +B 2.75,0.677 3.24,0.885 0.49,0.208 10 false HT1B 0.5,1.573 0.813,1.781 0.313,0.208 10 false E2 0.115,0.094 0.333,0.271 0.219,0.177 10 false *a
*a Component without harness connected
(Heated Oxygen Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HT1B) - 2 (+B) 20°C (68°F) 5 to 10 Ω
1 (HT1B) - 4 (E2) Always 10 kΩ or higher


If the result is not as specified, replace the heated oxygen sensor.